Automatic Lubrication Systems LLC header
Lubricators button
Lubricator Installation button
Lubricator Dispenser Settings button
Lubricator Applications button
Frequently Asked Questions button
Accessories button
Accessories button

Lubricators

Installation Instructions

  1. Pregrease bearing with standard hand lube gun to ensure that lubricant will flow smoothly into bearing. Use same grease as in dispenser.
  2. Remove grease nipple and screw in appropriate adaptor if necessary. Small Lubrication dispenser has 1/4”, large unit 1/2” NPT mounting nipple. Use adaptors if necessary to mount lubrication unit.
  3. If possible, install automatic lubrication dispenser directly onto bearing. If there is no clearance, an extension of up to 3 ft (for grease) and 15 ft (for oil) may be installed (use 1/4” I.D.). Before installing dispenser, fill extension with appropriate lubricant with standard hand lube dispenser.
Photo showing pre-grease of bearing with manual handpump Photo showing removal of grease nipple Photo showing adaptor installed Photos showing lubrication dispenser installed on bearing
Pre-grease bearing with hand pump Remove grease nipple Install adaptors Screw on lubrication dispenser

 
  1. Remove protective lid.
  2. Select desired DIP switches for appropriate lubrication output. See Table 1 for single and multiple switch settings.
  3. DIP switch 7 activates the indicator light. This optional setting causes the light to blink every 10 seconds and indicates if the electrical system is working properly.
  4. Replace protective lid and record installation/service date in logbook.
Photo showing lid removed Photo showing setting of running time by setting dip switches Photo showing setting of dip switch 7 Photo showing all dip switches set to off
Remove protective lid Set running time with DIP switch settings DIP switch 7 activates indicator light To turn off, set all switches to bottom position